BETAFPV Beta65S Tiny Whoop with F4 SPI Frsky Receiver OSD Smart Audio Z02 Camera 17500KV 7x16mm Motors for Tiny Whoop Racing
3 improvement based on Beta65 drones.
Motors: 6x15mm -> 7x16mm brushed motors
Frsky Receiver:F3 FC -> F4 FC SPI Frsky OSD - The latest BETAFPV F4 brushed FC has upgraded firmware to Betaflight 3.4.1, SPI Frsky D16(Default Configuration) connection works in this F4 flight controller.
Cam: Z01 Cam -> Z02 Cam - This Z02 FPV Camera is customized for Micro FPV quadcopter like Tiny Whoop etc. Support the SmartAudio function and adjustable output power, has wide lens angle of 100 to 120 Degrees with 1/4 lens.
The binding procedure is reversed as usual. No need to click the bind button when power on.
Power on the board, either by connecting the battery or USB power. Then the green receiver LED start to flash.
The second step, click the bind button for 3s. Then the green receiver LED will be solid on. This means that the receiver is in bind mode and you could start to bind your radio transmitter.
For detailed procedure of binding, please check the here: https://betafpv.freshdesk.com/support/solutions/articles/27000021366-how-to-bind-your-radio-transmitter-brushed-fc-board
Weight:25g (without battery)
Flight Controller: F4 Brushed FC SPI Frsky with OSD-UK: https://www.amazon.co.uk/dp/B07DMDZ1LH
Firmware Version: Betaflight MATEKF411RX 3.4.0
Motor: 7x16mm Coreless Brush Motor, 19000KV
Receiver: Frsky D16 potocol
Camera: Z02 Camera -https://www.amazon.co.uk/dp/B07FNRLFGZ
Batterry: 300mAh Lipo HV battery with PowerWhoop connector
Flight time: 3 minutes 30s seconds
1 * Beta65S BNF Frsky
1 *300mAh 1S Lipo HV Battery
Upgrade with F4 FC brushed SPI Frsky receiver and Z02 FPV camera. The default configuration from factory is Frsky D16 mode (FRSKY_X). Built in Frsky receiver is compatible with Taranis, Taranis Plus, X9E, Horus X12S, XJT Modules. In Betaflight Configuration, it should be setted as FRSKY_D receiver (aka Frsky D8 mode) or FRSKY_X receiver (aka Frsky D16 mode) in SPI RX mode. Refresh the receiver: https://oscarliang.com/flash-frsky-rx-firmware/
This is a SPI Frsky receiver. Binding easier than before, no need to click the bind button when power on. Guidance of Binding: https://betafpv.freshdesk.com/support/solutions/articles/27000021366-how-to-bind-your-radio-transmitter-brushed-fc-board
F411 Processor can reach to 100MHz, much faster than the F3 Flight Controller with 72Mhz. Integrated with Frsky receiver only.
More punch on throttle with faster 19000KV 7x16mm motors and 3-blade propellers.
Some basic guidance and typical FAQ, please check it here : https://betafpv.freshdesk.com/support/solutions